Chapter 2. Getting Started
STACK ST8302 and ST8360 Video-Logger System
8
User Guide
The following table shows the recommended operational differences
between LAN-C and non LAN-C recorders:
V
VS
LAN-C Non-LAN-C
RECORD switch = Toggle log +
Reset Peaks, Laps and PLT
RECORD switch = Reset Peaks,
Laps and PLT (if Memory Card
or Tape is full)
RECORD switch = Reset Peaks, Laps and
PLT
Must turn off “Start RPM” test to prevent a
reset every time the Engine Speed goes
through 3000rpm
Must use Display System (ST8100) switches to Reset Peaks, Laps and PLT
Turn on “Peaks MPH” test only if the vehicle has its ignition off on the grid. This
will prevent peak values being shown as the race starts
Recorder automatically stops
recording when V/VS module is
switched off
Recorder may or may not stop recording
when V/VS module is switched off
Relies on Engine Speed
exceeding the “Start RPM” test
value to start recording
Recorder must be started manually
PLT = Predictive Lap Timer (“Max” systems only)
Table 1 – LAN-C and non LAN-C Video Recorders
