Page 55 of 60
Spirit Fires Limited. 4 Beaumont Square, Aycliffe Industrial Park, Newton Aycliffe, County
Durham, DL5 6XN. Tel : 01325-327221 Web :
www.spiritfires.co.uk
menu.
•
Press and release the “set” button several times until
CAO
appears on the
display
(CA means Cancel All)
.
•
Press and release the “+” button once to change the display to
CA1
. Press
and release the “set” button once more and the display will change to say
the word TESC as shown in the image adjacent.
•
The handset is now free to pair again.
Step 2 - Pairing the Gas Control with the handset
This can only be done after the handset has been made free to pair as shown in
step 1 above:
•
Ensure all the batteries are fitted correctly and with the power isolator slide
switch on the TESC Fire control put in the “I” position – eg ON.
•
Place the handset within 1 metre (3 feet) of the gas fire.
•
Simultaneously press and hold the – and + buttons on the fire control
(
WARNING – the control in the fire not the hand set
) until the RED LED
light on the gas control starts to illuminate. Immediately as it does so, press
the power button on the gas control and the handset makes a noise and the
display shows a symbol like a number 7 back to back with a reverse number
7.
•
Then within a minute hold the handset to unlock the keypad a green unlock
light will illuminate when the handset has detected your hand. The green
light must be illuminated in this way for any of the command buttons to
accept commands to operate the fire control.
•
While the display is as described and holding the handset as described, press
the “SET” button with the other hand to accept the pairing request to finish
off the pairing of the handset to the Fire Control and to enter the setup the
time of day on the handset as described in previous sections.
N.B.
If the display returns to the one shown above with the word “TESC”
shown, then too much time has passed before pressing “SET” and so the
handset has not paired yet. Simply repeat pairing again.
N.B.
Only ever press “+” and “-“ buttons together when pairing handsets. If
done afterwards this will break the pairing made and a factory reset of the
handset will need to be performed See Factory Reset of display handset later on
in the instructions.
Snooze (in manual mode)
Snooze mode is a time period you can set which will turn off the fire after a
certain time period has elapsed.
The snooze time period can be set before or during manual operation of the
fire. Hold the handset to unlock as described previously and press the mode
