Speedtouch SpeedTouch 716v5 (WL), Cli Reference Manual

Page: 38 / 796

ATM Commands
E-DOC-CTC-20060414-0006 v1.0
16
atm ifconfig
Configure an ATM interface.
SYNTAX:
where:
The interface to be configured must not be connected at the time of configuration. If this should be the
case, use the command
:atm ifdetach before using the command :atm ifconfig .
atm ifconfig intf = <string>
[dest = <string>]
[qos = <string>]
[encaps = <{llc | vcmux}>]
[retry = <number{0-65535}>]
[fcs = <{disabled | enabled | auto}>]
[ulp = <{ip | mac | ppp}>]
intf The name of the ATM interface to be configured. REQUIRED
dest The WAN destination for this ATM interface.
Typically, an ATM phonebook entry. OPTIONAL
qos The name of the Quality of Service (QoS) book entry to apply on this ATM interface.
The default is
default .
OPTIONAL
encaps The type of encapsulation to be used for this ATM interface.
Choose between:
llc : Logical Link Control (LLC) / Sub Network Access Protocol (SNAP)
vcmux : Virtual Channel MUltipleXing (VCMUX).
The default is llc .
OPTIONAL
fcs Enable or disable the inclusion of the Ethernet Frame Check Sequence (FCS) in the
packet header on the WAN side (only used for llc encapsulation for mac).
The default is
disabled .
Note
This parameter is normally left disabled.
OPTIONAL
retry A number between 0 and 65535.
Represents the number of times the SpeedTouch™ retries to set up a WAN connection
before giving up.
The default is
10 .
OPTIONAL
ulp Select the Upper Layer Protocol (ULP) for this interface.
Choose between:
ip (for a Routed IPoA interface).
mac (for a Bridged Ethernet, Routed ETHoA, Bridged PPP over Ethernet (PPPoE),
Routed PPPoE or a PPPoE Relay interface).
ppp (for a Routed PPP over ATM (PPPoA) interface).
The default is ip .
OPTIONAL