13
Product to tank: Route the product water into the top
of a vented tank, or a tee in the water tank fill hose.
DO NOT feed into a vent line, manifold, or into the
bottom of the tank. Bladder tanks will create too much
back pressure. There must be no restriction or back
pressure whatsoever in this piping.
Salinity Probe
Diversion Valve
The 1/4”(6mm) product water tubing is pre-plumbed from the membrane into the electric di-
version valve. The diversion valve will reject product water into the overboard brine stream
until MPC-5000 control determines the product water is below 750 PPM salinity. Once below
750 PPM, the MPC 5000 control opens the diversion valve and product water is diverted into
the fresh water tank. For plumbing to the fresh water tank, see the Parker tube fitting assem-
bly diagram on next page
.
Product Diversion Valve Manifold
RotoFlow Meter
Accepted Product
Water Outlet
Rejected product outlet
Product from membrane
Check Valve
Product Water Plumbing
Summary of Contents for Ventura 150T MPC
