Alarm Management
NVR User Manual
42
9
Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each camera and then set up the alarm handling of each camera.
①
Click Start
Settings
Alarm
Sensor Alarm to go to the following interface.
②
Select schedule and the alarm type (NO or NC) according to trigger type of the sensor.
③
Enable the sensor alarm of each camera.
④
Check the “Duration”, “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and enable or disable the “Buzzer”, “Pop-up Video”, “Pop-up
Message Box” and “E-mail” as required.
⑤
Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration:
it refers to the interval time between the adjacent motion detections. For instance, if the duration time is set to 10 seconds, once the
system detects a motion, it will go to alarm and would not detect any other motion (specific to camera) in 10 seconds. If there is another motion
detected during this period, it will be considered as continuous movement; otherwise it will be considered as a single motion.
Record
: check it and then the “Trigger Record” window will pop up automatically (you can also click “Configure” button to pop up the window).
Select camera on the left side and then click
to set the camera as the trigger camera. Select trigger camera on the right side and then click
to cancel the trigger camera. Click “OK” button to save the settings. The trigger cameras will record automatically when the sensor alarm is
triggered.
Snapshot
: check it and then the “Trigger Snapshot” window will pop up automatically. Configure the trigger camera in the window. The trigger
cameras will snap automatically when the sensor alarm is triggered.
Push:
check it and choose NO or OFF. If it is ON, the system will send messages when the sensor alarm is triggered.
Alarm-out
:
check it and then the “Trigger Alarm-out” window will pop up automatically. Configure the trigger alarm-out in the window. The system
will trigger the alarm-out automatically when the sensor alarm is triggered. You need to set the delay time and the schedule of the alarm outputs.
See 9.5.1 Alarm-out for details.
Preset
:
check it and then the “Trigger Preset” window will pop up automatically. Configure the trigger preset of each camera. To add presets, please
see 6.2 Preset Setting for details.
Buzzer
:
if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the delay time of the buzzer, please see 9.5.4 Buzzer for
details.
Pop-up Video
:
After camera setting, the system will pop up the corresponding video automatically when the sensor alarm is triggered. To set the
duration time of the video, please see 9.5.3 Display for details.
Pop-up Message Box
: if enabled, the system will pop up the corresponding alarm message box automatically when the sensor alarm is triggered. To
set the duration time of the message box, please see 9.5.3 Display for details.
:
if enabled, the system will send an e-mail when the sensor alarm is triggered. Before you enable the email, please configure the recipient’s
e-mail address first (see 11.1.5 E-mail Configuration for details).
9.2 Motion Alarm
Motion Alarm
: when the motion object appears in the specified area, it will trigger the alarm. You should enable the motion of each camera first
and then set the alarm handling of the camera to complete the whole configuration of the motion alarm.
9.2.1 Motion Configuration
①
Click Start
Settings
Camera
Motion to go to the following interface.
