![background image](http://html1.mh-extra.com/html/specac/atlas-automatic-40-ton/atlas-automatic-40-ton_user-manual_1341494009.webp)
Atlas™ Auto 40T Hydraulic Press
7
Remove the 8 coach bolt (nuts & washers) and blocks securing the 2
retaining timber ribs. Take out the 2 ribs. Remove the 4 screws
securing the 50mm x 50mm timber on the inside. Remove the 50mm x
50mm timber by “knocking” upwards if necessary.
The press is now ready to be lifted out of the wooden pallet.
NOTE:
The press MUST be lifted into its working position using a
suitable hoist (or crane) with a lifting hook to pass through
the eye bolt. DO NOT ATTEMPT TO LIFT THE PRESS BY
ANY OTHER METHOD. When the press has been installed
and the lead screw assembly has been fitted, for any
subsequent possible repositioning, the press should
NEVER be lifted via the lead screw handle. Always use the
lifting eye bolt assembly pieces for a re-siting operation.
The press can now be lifted upwards and out of the pallet/box using a
crane, after attaching the crane hook to the press lifting ring on the top.
The leadscrew assembly and mains power cable will also be located in
the box. Cut the straps that hold these items in place.
Place the press in its working position. The bench worktop should be of
a minimum thickness of 25mm. The press needs to be sited near to an
electrical power supply and also near to a water supply and drainage
sink if the Atlas™ Heated Platens P/N GS15515 are used.
Removing the Lifting “Eye Bolt” Assembly
You will need to dismantle the lifting eye bolt pieces from the Atlas™
Auto 40T press and fit the lead screw assembly before the press can
be used.
Before the lead screw assembly can be put in place the internal
packing in the press has to be removed. Cut the tape at the top of the
plastic bag and around the base of the bag and lift clear of the press.
You will see that there is further protective packing within the pressing
area of the press behind the safety guard. The safety guard is in the
down position and held in place by sticky tape to the base of the press
on the outside. Remove the sticky tape and lift up the safety guard via
Summary of Contents for Atlas Automatic 40 Ton
