Sony PXW-X500, Service Manual

Page: 106 / 184

2-13. DC Fan (40 Square)
Preparation
1. Remove the outside panel assembly. (Refer to “2-2. Outside Panel Assembly” )
2. Remove the bracket (WA) assembly. (Refer to “2-6. Wi-Fi Module/SD-58 Board” )
3. Remove the inside panel assembly. (Refer to “2-3-1. Inside Panel Assembly” )
4. Remove the DCP-67 board. (Refer to “2-9. DCP-67 Board” )
5. Remove the HPR-53 board. (Refer to “2-10. HPR-53 Board” )
6. Remove the DPR-362 board. (Refer to “2-11. DPR-362 Board” )
7. Remove the EC-82 board. (Refer to “2-12. EC-82 Board” )
Procedure
1. Release the fine-wire coaxial cable from the clamper, and disconnect the harness.
1) Remove the tape AS.
2) Release the fine-wire coaxial cable from the clamper.
3) Disconnect the harness from the connector (CN13) on the MB-1210 board.
Fine-wire coaxial
cable
CN13
(MB-1210 board)
Harness
Tape AS
Clamper
Duct box
Harness
Note
When connecting the harness, arrange the harness under the duct box as shown in the figure.
PXW-X500
2-52