Sony PXW-X500, Service Manual

Page: 99 / 184

2-11. DPR-362 Board
Preparation
1. Remove the outside panel assembly. (Refer to “2-2. Outside Panel Assembly” )
2. Remove the bracket (WA) assembly. (Refer to “2-6. Wi-Fi Module/SD-58 Board” )
3. Remove the inside panel assembly. (Refer to “2-3-1. Inside Panel Assembly” )
4. Remove the DCP-67 board. (Refer to “2-9. DCP-67 Board” )
5. Remove the HPR-53 board. (Refer to “2-10. HPR-53 Board” )
Procedure
1. Disconnect the fine-wire coaxial cables and the coaxial cables.
1) Release the fine-wire coaxial cable from the clamper.
2) Disconnect the four fine-wire coaxial cables from the four connectors (CN2302, CN5201, CN5202, CN5400)
on the DPR-362 board.
3) Disconnect the three coaxial cables from the three connectors (CN SDI1, CN SDI2, CN SDI3) on the DPR-362
board.
Fine-wire coaxial cable
Fine-wire coaxial cables
Clamper
Coaxial cable (White)
Coaxial cable (Gray)
Coaxial cable (Yellow)
CN2302
CN5201
CN5202
CN5400
CN SDI3
CN SDI2
CN SDI1
DPR-362 board
Fine-wire coaxial cable
Note
When connecting the coaxial cables, connect the coaxial cables to correct connectors.
PXW-X500
2-45