138
Chapter 6
Meetings With the Multipoint Function
Chapter 6
Start Meeting:
Starts the conference with the parties
currently connected
Disconnect All:
Disconnects all parties and returns to the
Launcher menu.
Redial:
Redials the numbers for the locations that failed to
connect.
To hold a meeting with registered remote parties and
unregistered parties mixed
Based on the registration status of the remote parties, you can
follow either steps
1
to
5
of [Calling previously registered
remote parties], or steps
1
to
4
of [Calling unregistered remote
parties], to make your connections.
Receiving Calls
The procedure is same as a normal meeting.
For details on the procedure, see “Receiving a Call” on page
49.
Notes on Point to Multi-Point Meetings
See also “The Attribute” on page 145.
• The chair control is only available from this terminal. Remote
parties cannot operate it.
• This system does not support multiplex MCU connections.
• The number of lines is set to two when Number of Lines is set
to 2B; is set to one when set to 1B. This is regardless of the
setting in the Dial Setup menu.
• One ISDN jack can connect with only one terminal. Even if
you connect via 1B-channel, the number of remote parties is
up to three.
• The conference on the video telephone is available in only
one location and the 1B connection is established.
• This system does not support connections via the Inverse
Multiplexer interface (BONDING).
Starting a Point to Multi-Point Meeting
