Sony Ipela PCS-G50, Operating Instructions Manual, Page: 145 / 259

145
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
To connect to a computer via a hub
Connect the Communication Terminal to a computer using the UTP straight
cable.
To configure the Communication Terminal
Open the “Device Setup” on page 1 of the General Setup menu, and then enter
the IP address of the computer where the NetMeeting application is installed
in the “T.120 PC Address” text box. (See page 57.)
Set “T.120 Data” to “On” on the Communication Setup menu. (See page 51.)
We recommend that you set “Audio Mode” to “G.728” on the Communication Setup
menu.
To connect to a remote party using NetMeeting
Before connecting, install the NetMeeting application in your computer.
1
Double-click the NetMeeting icon, or click “NetMeeting” from the Start
menu on the computer’s window.
NetMeeting starts.
2
Set the Communication Terminal to communication mode.
Check that the “T.120” indicator is displayed on the monitor screen.
3
Click “Calling” in the NetMeeting window on the computer of either a
local or remote party.
4
Enter the IP address set for the Communication Terminal in the “Address”
text box of the “Call to” dialog box.
Note
TERMINAL VISCA OUT
(MIXED) AUX
AUX MONITOR
LINE
AUX CONTROL
VIDEO OUT
AUDIO OUT AUDIO IN
MIC
VIDEO IN
EC-MIC
CTRL-S
RGB OUT DSB
ISDN UNIT
IR OUT
1 2
1 2
1 2
1 2
DC 19.5V
CAMERA AUX IN
WHITE
BOARD
100BASE-TX/
10BASE-T
(PLUG IN POWER)
to 100BASE-TX/
10BASE-T
Computer
UTP straight cable (not supplied)
to LAN connector
Hub