— 23 —
Fig. 4-10.
4-10. LS Chassis Block Assembly
1. Removal procedure
1)
Move the LS chassis block assembly between
[USE]
and
[LOAD]
.
2)
Remove the blind plate. (Refer to 4-5.)
3)
Remove the R drive gear assembly. (Refer to 4-8.)
4)
Remove the HCL cut (1.8
×
4
×
0.5)
1
.
5)
Remove the three screws (M1.4
×
2.5)
2
.
6)
Remove the LS chassis block assembly
3
in the direction of
the arrow
A
.
2. Attachment procedure
1)
Insert the LS guide roller and LS guide T2 pin of the mechanical
chassis block assembly into the slot of the LS chassis block
assembly
4
.
2)
Insert the pin of the LS arm assembly into the cam groove on
the LS cam plate, face the TG7 drive pin
5
in the direction of
the arrow
B
, and insert it to the two slot of the mechanical
chassis. Then, tighten the three screws (M1.4
×
2.5)
2
in the
order of
C
,
D
and
E
.
Tightening torque: 0.078 ± 0.01 N•m (0.8 ± 0.1 kgf•cm)
3)
Attach the HCL cut (1.8
×
4
×
0.5)
1
to the pin of the LS arm
assembly.
4)
Attach the R drive gear assembly. (Refer to 4-8.)
5)
Attach the blind plate. (Refer to 4-5.)
6)
Clean the tape running path. (Refer to 2-2.)
Note:
Each arm must move smoothly.
2
Three screws
(M1.4
×
2.5)
1
HCL cut
(1.8
×
4
×
0.5)
LS cam plate
Cam groove
3
Remove the LS chassis
block assembly in the
direction of the arrow
A
.
When attaching it, coat the
hatched portion
with grease.
When attaching it, coat the hatched
portion with grease.
A
LS guide
T2 shaft
4
Slot of LS chassis
(at two locations)
LS guide roller
5
TG7 arm block
assembly
LS arm assembly
Mechanical chassis block assembly
Pin
6 to 8mm
B
Do not
bend here.
C
D
E
