— 12 —
3-2. Cassette compartment assembly
1. Removal procedure
1)
Set the
[EJ]
mode to move up the cassette compartment
assembly
0
.
2)
Remove the capstan flexible board and flexible wiring board
(FP-300)
1
from the holders
X
,
Y
and
Z
in the directions
of the arrows
A
,
B
and
C
.
3)
Push the damper assembly
3
in the directions of the arrows
D
and
E
and remove it from the notch of the LS chassis block
assembly.
4)
Remove the two screws (camera pan2 main M1.4
×
1.6)
4
.
5)
With the cassette compartment assembly
0
half opened, move
the face plate in the direction of the arrow
F
and remove it
from the grooves
6
and
7
on the LS chassis block assembly.
6)
Remove the cassette holder (S)
8
and cassette holder (T)
9
of the cassette compartment assembly
0
from the groove on
the LS chassis block assembly.
2. Attachment procedure
1)
Set the
[USE]
mode.
2)
Insert the cassette holder (S)
8
of the cassette compartment
assembly
0
and cassette holder (T)
9
into the grooves on
both sides of the LS chassis block assembly.
3)
While moving down the cassette compartment assembly
0
,
lift up the face plate in the direction of the arrow
F
and keep
this status. Then, insert the face plate in the grooves
6
and
7
on the LS chassis block assembly.
4)
Tighten the two screws (camera pan2 main M1.4
×
1.6)
4
.
Tightening torque: 0.078 ± 0.01 N•m (0.8 ± 0.1 kgf•cm)
5)
Move the damper arm of the damper assembly
3
to the 4
o’clock position and insert the damper assembly into the hole
on the LS chassis block assembly and the dowel of the cassette
holder (T)
9
.
6)
Align the damper assembly
3
with the notch of the LS chassis
block assembly and rotate the damper assembly
3
in the
opposite direction to the arrow
E
to fix it.
