Sony CineAlta HDCAM HDW-F900R, Maintenance Manual, Page: 57 / 546

1-47
HDW-F900R/V1 (E)
9. Connect the harness that is removed the DCP-43
board, to the connector (CN1) on the EX-776 board.
Connect the harnesses of the EX-776 board to the
connector (CN3) on the DCP-43 board.
10. Connect the flexible card wire (30 core) to the connec-
tor (CN1) on the DR-614 board and to the connector
(CN105) on the DCP-43 board.
1-15-12. Extending the Mechanical Deck
Assembly
Required tools : EX-764 board (3 boards),
Flexible card wire (45 core, 250 mm) (6 wires)
n
Life of flexible card wire will be significantly shortened if it
is folded. Be very careful not to fold the flexible card wire.
1. Remove the outside panel assembly. (Refer to Section 1-4.)
2. Open the inside panel assembly. (Refer to Section 1-5.)
3. Remove the DCP board assembly. (Refer to Section 1-7-1.)
4. Remove the DVP board assembly. (Refer to Section 1-7-2.)
5. Remove the harness clamp.
6. Remove the five screws and remove the dust protec-
tion cover.
7. Remove the flexible card wires from the connector
(CN101) on the MB-1096 board, the connectors
(CN201 and CN202) on the SS-92G board and the
connector (CN4) on the MDR-14G board.
DR-614 board
EX-776 board
DCP-43 board
CN1
CN1
CN3
CN105
Flexible card wires
(30 core)
CN201
CN202
SS-92G board
MB-1096 board
MDR-14G board
Flexible card wire
Flexible card wires
CN101
CN4
PSW2 x 5
Dust protection
cover
Harness clamp