Sony CineAlta HDCAM HDW-F900R, Maintenance Manual, Page: 419 / 546

8-13
HDW-F900R/V1 (E)
Adjustment Procedure
3. T tension regulator operating position adjustment
(1) Loosen the adjustment screw of the eject link assembly (B) by 1/2 turn.
(2) Insert the 3 mm flat head screwdriver tip into the adjustment hole of the eject
link assembly (B) and adjust position of the eject link assembly (B) until the
specification is satisfied.
(3) While maintaining the screwdriver setup as step (2), tighten the adjustment
screw of the eject link assembly (B).
Standard tightening torque : 20
x 10
_
2 N . m (2.0 kgf . cm)
(4) Confirm that the operating position of the T tension regulator satisfies the
specifications.
4. Releasing the mode
Rotate the manual eject gear (A) clockwise until the unit reaches the unthreading-
end state. (Refer to Section 7-1-4.)
5. REV back tension adjustment
(Refer to Section 8-1-4.)