Sonic KCS-5200, Operation Manual

Page: 96 / 153

9-6
13. LED UP: Lights when the hoist unit is ascending.
14. LED DOWN: Lights when the hoist unit is descending.
15. LED HSTT2: Flickers when a communication signal is output to processor 2 from the 2HPC-2S
board. Only in the case of a 2-wave system. Not used in another system. (It appears to be lit.)
16. LED HSTT1: Flickers when a communication signal is output to processor 1 from the HPC-2S
board.
(It appears to be lit.)
17. Rotary SW: Used for determining the sonar system.
18. Slide SW: Used for determining the sonar system.
19. Auto/Manu toggle SW: Used for switching between AUTO and MANU.
20. Manu switch: Used when performing lifting, lowering, rotating and tilting operations manually.
After the power is switched ON, the 7-segment LED lights as follows.
(1) Version information for HPC-2 software (Lights for about 1 seconds.)
(2) Information concerning the model name and size of the hoist (Lights for about 1 second.)
(3) Information concerning the lifting and lowering distance, roll angle, pitch angle, and degree of
rotating (Condition under normal use)
The following are the standard values displayed on the 7-segment LED. The actual displayed values
may sometimes differ from them.
昇降量
HOIST
Upper limit Lower limit
00
（
HEX
）
7F
（
HEX
）
旋回量
BEARING
Right limit Center limit Left limit
F8
（
HEX
）
00
（
HEX
）
08.
（
HEX
）
俯角量
TILT
0(deg) 90(deg)
00
（
DEC
）
90
（
DEC
）
ロール、ピッチ角
ROLL
、
PITCH
51(deg)
0
（
deg
）
-51(deg)
51
（
DEC
）
0
（
DEC
）
51.
（
DEC
）
Note 1) The dot display on the 7-segment LED respresents a minus sign.
Note 2) The BEARING and TILT are displayed when the HALF LED is ON and the X-Y LED is OFF.
Note 3) The inclination of ROLL and PITCH is displayed when the STB and X-Y LEDs are lit.