Sonic KCS-5200, Operation Manual

Page: 95 / 153

9-5
・
Name of each part of the HPC-2SPCB
Description
1. LED HCTL1: Flickers when a communication signal from processor 1 is input.
2. LED HCTL2: Flickers when a communication signal from processor 2 is input.
Only in the case of a 2-wave system. Goes out in the case of another system.
3. LED IMU: Used for checking the inclinometer power supply (+12 V). Lights in the case where
the the system has a stabilizing function. Goes out in the case of another system.
4. LED +12 V: Used for checking the +12V power supply. Normally lit.
5. LED Vcc: Used for checking the +5 V power supply. Normally lit.
6. LED +24 V: Used for checking the +24 V power supply. Lights in the case of a KCH-5180 half
scanning sonar system. Goes out in the case of another system.
7. 7-segment LED: Described later.
8. Information LED: Described later.
9. LED MPC TxD: Flickers when inclination data is output. Lights when the system has a stabilizing
function. Goes out in the case of another system.
10. LED MPC High: Lights in the case of the KCS5221Z or the KCS-5885Z system.
11. JP MPCTX2(JP2): Determines the inclination data format.
12. JP MPCTX1(JP1): Determines the inclination data format.
③
LED IMU
②
LED HCTL2
①
LED HCTL1
④
LED +12V
⑤
LED VCC
⑥
LED +24V
⑩
LED High
⑨
LED MPC TxD
⑪
JP MPC TX2(JP2)
⑬
LED UP
⑭
LED DOWN
⑮
LED HSTT2
⑯
LED HSTT1
⑰
Rotary SW
⑲
Auto/Manu toggle SW
⑦
7-segment LED
⑫
JP MPC TX1(JP1)
⑱
Slide SW
⑧
Information LED
⑳
Manu switch