Solwise Elite VoIP Gateway User’s Guide
96
5.12.3.7 set coding
profile_id
fax_tx_net_timeout
This command sets the timeout period after which the ITG will declare a fax
cleardown event, if no data is received from the IP network while the gateway is in a
local transmit state. It is safeguard to ensure the channel is not left in a fax relay state
in a transparent signaling environment.
set coding profile_id fax_tx_net_timeout seconds
Syntax description
seconds
Value in seconds, ranging
from 10 to 32000.
5.13 Call Progress Tone Configuration Commands
Cal Progress (CP) tones such as ring-back, busy, congestion and disconnect tone are
signaling tones PBXs and CO switches present at various stage of a call. Telephony
device, or user operating it, must act upon the CP tones generated by device
connected to it for completing a call. The ITG implements a CP generator for
generating CP tones and a detector for detecting CP tones. Since the frequency
specifications and on/off cadence of CP tones are not uniform over all telephone
administrations globally, the ITG implements user configurable CP tone
generator/detector allowing user to customize the CP tone generator and detector.
This section describes commands for configuring the CP tone generator and detector.
5.13.1 Configuring CP Tones
A CP tone is a sequence of tones of up to 6 elements, and each tone element is
characterized by a composition of up to 4 mono-frequency tones and a duration that
the tone generator plays out these tones. Once configured, the CP tone generator
plays these tone elements, in sequence, repeatedly. The ITG allows users to define
the tone elements and duration for the following CP tones:
Dial tone
Busy tone
Congestion tone
Disconnect tone
This section describes the command for configuring these tones.
5.13.1.1 set tone
This interactive command is used to configure the each of the element of the CP
tones that the ITG generates.
set tone {dial | busy | congest | disconnect}
Syntax description
dial
Dial tone
