Solwise Elite VoIP Gateway User’s Guide
112
Use
set
commands to make configuration parameters changes in the Temporary
area
Use the
config activate
command to move the new values into the Active
area, available for use
Use the
config store
command to save the new Active values in NVS
Reset the ITG after changing H.323 settings and storing the setting to NVS.
5.15.1 config
This command is used to move data among Temporary, Active and NVS areas.
config {activate | store | erase}
Syntax Description
activate
Move the configuration from
temporary area to active area.
store
Store the active configuration data
into non-volatile storage.
erase
Erase the configuration from non-
volatile storage.
5.16 The Show Command
The show commands are used to display information about the ITG. This section
describes the show command.
5.16.1 show call_record
This command displays the information about the current call, if call is on-going, or
the last call, if the call has been completed, for a telephony port. Information
displayed include:
Originator of the call, local or remote.
Terminator of the call, local or remote.
State of the call
Release reason of the call
Times, since system was powered up, the line was seized.
Time, since seizure of the line, the call was connected.
Duration of the call
Coding profile the call employed.
show call_record port
Syntax description
