Softing FG-200 HSE/FF, User Manual

Page: 55 / 82

Chapter 7 - Redundancy mode
Version EN-112021-1.30.3
55
7.3 Configuration of a redundant pair of FG-200
Webserver interface
Make sure that both FG-200s have a different IP address. Refer to Chapter Configuration for a detailed
description.
To realize a redundant pair of FG-200s a serial link between both devices is necessary. Deactivate
Enable
RTU . To do so, go to Configuration
à
Settings
à
General Settings in the webserver interface and
deselect the option Enable RTU .
After modifying the configuration settings click [Change Settings] to apply the new settings and to reboot
the FG-200. Make sure to apply these configuration settings on both FG-200s.
Detect primary and secondary FG-200
To detect primary and secondary FG-200 go to Diagnostics
à
Internet Protocol . In the respective entry
in line Redundancy State you will see Primary, no backup for the primary device and Secondary for the
secondary device.
Then go to Diagnostics
à
Fieldbus and note down the Device ID for the respective FG-200.
comConf
1. To configure a redundant FG-200 with the comConf select the FG-200 within the project manager or
topology and open the Properties View.
2. Enter the IP address in the corresponding fields of the secondary FG-200.
3. Save the values with Ctrl+S.
4. From the
Build menu select the command Build All (or press Alt+F8 ).
5. Generate Code for the current segment.
6. Select
Download
à
Download Project .
Synchronize Modbus mapping tables
To synchronize Modbus mapping tables of primary and secondary device, import the mapping tables
generated with comConf in both the primary and secondary FG-200.
25
33
34