Softing FG-200 HSE/FF, User Manual

Page: 16 / 82

FG-200 HSE/FF Modbus - User Manual
16
Version EN-112021-1.30.3
3.1.3 Connection diagram
The following connection diagram shows the physical interfaces of the FG-200.
3.1.4 Connecting the power supply
1. Connect the FG-200 to a 24 V DC power supply.
2. Use different or redundant power supplies for redundant FG-200s.
3. Turn on the power supply. The boot process takes approx. 50 seconds. For indication of proper
operation of a FG-200 acting in non-redundant mode or as primary device in redundant mode refer to
LED status indicators .
The supply voltage (18 VDC .... 32 VDC) is connected by a 3-pole terminal block. The power supply is
connected to the plug connector via flexible wires with a cross section of 0.75 to 1.5 mm². The ground
connection wire must have a cross section of 1.5 mm².
Pin Signal Description
1 GND Ground
2 Functional earth
3 L+ Positive supply voltage
CAUTION
The Functional Earth (FE) connection of the device has to be connected at low inductance
with the Protective Earth (PE) of the system.
57