Chapter 4
Installation and Start up
Operating instructions
Page 4-3
4.1 Installation of the Equipment
The installation section of this chapter informs the user about all
steps for user installation and start-up of the MAGLUMI
®
Analyzer.
The original installation of the analyzer will be accomplished by a
certified technician,trained in accordance with SNIBE regulations.
In this chapter, the user will be led step by step for all necessary
installation processes to the setting up of the system.
For maintaining the safety of the user, the installation and
start-up of the MAGLUMI Diagnostic System may only be
performed by trained persons authorized by SNIBE.
The MAGLUMI Diagnostic System may only be installed and
used under the working conditions (temperature, altitude, no
direct sunlight exposure and humidity) defined in these
Operating Instructions.
4.1.1 Electrical connections of the system
Arrangement of the equipment from left to right: PC – Analyzer
PC Connections
1. Install the Monitor, Keyboard, & Mouse to the back of the PC
connecting each cable
2. Install the touch screen cable from the monitor to the USB
Interface located on the back of the PC.
3. Install the supplied power cables to the Monitor, PC.
4. Connect the supplied RS232 cable to the COM 1 serial port
located on the backside of the PC.
Analyzer Connections
1. Connect the remaining end of the RS232 cable to the analyzer
RS232 jack located on the left side of the analyzer behind the
power switch.
2. Connect the supplied power cable to the analyzer.
3. Connect all power cables to the voltage supply.