k)
Secure the back box to the wall with suitable fixings to support a full
assembly weight, including the batteries, of 14kg.
l)
Terminate the cable at the entry point leaving 400mm tail wire length.
WARNING: The mains cable tail ends must be insulated to
prevent dangerous conditions arising in the event of accidental
switching ON of the mains supply.
m)
Secure the cover to the back box using the captive screw.
n)
Replace the cover to back box earth lead.
o)
Re-fit the door, earth lead and ribbon cables previously removed.
p)
Close the door and lock it using the door key. All remaining
installation is done during the commissioning of the system.
CAUTION: Do not connect the mains and battery cables, these
will be connected during the commissioning stage.
cdn11
Figure 6-7 Repeat Panel back box
Standalone System Installation
Fuses and locations
78910-03NM Issue 2_10/96
6-9
Senator II Installation Manual