g)
Remove the power supply cover by removing the three fixing screws
and loosening the two captive screws at the top of the cover.
h)
Knock out/in the required cable entry points from the back box.
NOTE: The battery cable can enter the backbox in one of two locations
(top-right or bottom-center right). Only knock out/in the one that is
required.
Flush mount
i)
If the panel is to be flush mounted then follow the instructions for
flush mounting control panel now. Once flush fixing is complete, or
if panel is to be surface mounted continue with j) below.
j)
Mark out the back box fixing points on the wall to which the panel is
to be mounted.
k)
Secure the back box to the wall with suitable fixings to provide
adequate support for a full assembly weight of 16kg.
l)
Terminate each cable at the entry point leaving 400mm tail wire
length and mark each core to identify its intended connection point.
WARNING: The mains cable tail ends must be insulated to
prevent dangerous conditions arising in the event of accidental
switching ON of the mains supply.
cdn3
Figure 6-2 Control Panel Back box shown without door
Standalone System Installation
Fuses and locations
78910-03NM Issue 2_10/96
6-3
Senator II Installation Manual