![background image](http://html1.mh-extra.com/html/smc-networks/lat3-series/lat3-series_operation-manual_1299750052.webp)
- 51 -
(11) Do not dent, scratch or cause other damage to the steel ball rolling surface of the table and
rail.
It will result in play or increased sliding friction.
(12) Positioning accuracy, thrust and measurement accuracy may vary after the Card Motor or
the workload have been mounted, depending on the mounting conditions and environment.
Calibrate them according to the actual application.
(13) Consider mounting an elastic bumper on the pushing surface.
If impact to the Card Motor cannot be avoided during pushing operation, it is recommended to
mount an elastic bumper.
【
Grounding
】
Warning
(1) Always ground the Card Motor.
(2) Use a dedicated grounding.
Use a D-class grounding. (Ground resistance less than 100
Ω
.)
(3) The grounding point should be as close as possible to the actuator, and the ground wires as
short as possible.
【
Unpacking
】
Caution
(1) Check that the received product is as ordered.
If a product different from the one ordered is installed or used, injury or damage can result.
5. 3 Mounting
(1) Read and understand the Operation Manual before installing and operating the product. Also
keep this manual available whenever necessary.
(2) Strong magnet.
The Card Motor contains a strong rare-earth magnet. If magnetized work pieces, tools and metallic
parts are brought in the vicinity of the Card Motor, they will be attracted, which could cause injury to
operators and damage the equipment. Take special care when handling and operating the product.
(3) Do not make any alterations or modification to this product.
Alterations or modification made to this product may lead to a loss of durability and damage to the
product, which can lead to human injury and damage to other equipment and machines.
(4) When an external guide is used, connect the moving part of the actuator and the load in such
a way that there is no jamming at any point along the stroke.
(5) Do not use the product until you have verified that the equipment can operate properly.
After mounting or repair, connect the power supply to the product and perform appropriate functional
inspections to check it is mounted properly.
(6) When mounting a work piece, do not apply impact or large moment to the Card Motor.
If an external force higher than the allowable moment is applied, it may cause play in the guide part
and an increase in the sliding friction or other damage.
Warning