![background image](http://html1.mh-extra.com/html/smc-networks/lat3-series/lat3-series_operation-manual_1299750015.webp)
- 14 -
Warning
Consider the table movement.
If the operation is ended (the motor becomes de-energized). Because no power is supplied to
the Card Motor the table will not be fixed and can be moved by external force or by the table’s
own weight (including workpieces). Check that the table movement cannot cause any human
injury or damage to the equipment.
Caution
When an alarm is generated.
If the LED [ALM] on the front of the controller turns red or
flashes, an alarm has been generated.
Press SVON to reset and cancel the alarm after the cause
of the alarm has been cleared.
SVON reset
Click [Servo On] first and then [Servo Off].
Note) The type of the alarm can be detected by checking the combination of lit and flashing
ALARM and POWER LED’s. Refer to section “8. Alarm detection” (P.60) or the LATC4 series
controller operation manual for details of alarm detection.
Complete the ”Basic Parameter Setup” and ”Step Data Setup” settings before operating the
Card Motor.
If the ”Basic Parameter Setup and ”Step Data Setup” settings have not been completed, the Card
Motor will not operate and an alarm will be generated. Refer to section “1.2 Controller settings” (P.7)
for details of Basic Parameter Setup” and Step Data Setup” settings.
In “Monitor Mode” it is not possible to operate the Card Motor with the Controller Setting
Software.
Refer to section ”1.4 (5) Monitor Mode” (P.19) for details of the “Monitor Mode”.
Click
Click
LED [PWR]
:
Green
LED [ALM]
:
Red