- 50 -
(2) When there is abnormal temperature rise, burning or smoking, shut off the power supply.
(3) Strong magnet warning.
In case abnormal operation noise or vibration occurs, the Card Motor may have been improperly
mounted or is loose. Unless operation is stopped for inspection, machinery can be seriously
damaged.
(4) When installing, adjusting, inspecting or performing maintenance on the Card Motor,
controller and related equipment, be sure to switch off the power supply to them first, then
lock it so that no one else except the person working on it can switch the power on, or
implement other counter measures such as using a safety plug.
(1) Check the product for the following matters before operation.
a) Any damage in the power line and each signal line.
b) Play and looseness in the connector of each power line and signal line.
c) Play and looseness in the mounting.
d) Abnormal operation.
e) Emergency stop of the equipment.
(2) When more than one person is working with the products, decide regarding the procedures,
signals, measures for emergency and how to start the operation after these measures have
been taken. Also, designate a separate person to supervise the work other than those working
with the products.
(3) Strong magnet.
The Card Motor contains a strong rare-earth magnet. If a magnetic card is brought close to the Card
Motor, the card data may get distorted or lost. Do not bring items, which are sensitive to or affected
by magnetism close to the product.
(4) Do not operate the Card Motor continuously with maximum thrust force.
The Card Motor may overheat due to the heat generated by the Card Motor itself, and a
temperature error or malfunction may occur.
(5) Do not hit the stroke ends during operation, except during return to Origin position and in
pushing operation.
Impact at the stroke ends may damage the Card Motor.
(6) For pushing operations, set the target position at least 1 mm away from the position where
the pushing tool comes into contact with the work piece.
Otherwise, the table may hit the work piece at a speed exceeding the specified pushing speed.
(7) Do not remove the product label.
(8) Initial operation tests should be performed at low speed. Begin to operate at the specified
speed only after confirming it cannot cause any trouble.
(9) Be careful not to touch, get caught or hit by the work piece while the actuator is moving.
It may cause an injury.
(10) The table and guide rail are made of special stainless steel, but can rust in an environment
where droplets of water adhere to it.
Caution