OM_Axessor_CIT_V024_20170518_EN.pdf Operating
Manual
Page 96
Subject to change without prior notice
Axessor CIT
6.4.5.14 Enabling/disabling Time Lock for OTM - Submenu TL
LOCK cit
Ex factory, a defined time lock period does not apply for OTM codes. OTM
codes can open always. If the defined time lock periods shall apply for
OTM codes as well, set this setting to „
ON
“.
Authorization: Master Code
1. Select submenu „
TL LOCK cit
“.
2. Press
the
<ENTER>
key. It is displayed if the time lock periods do apply
for OTM codes („on“) or not apply („off“).
3. Select either „
ON
“ or „
OFF
“ by toggling with the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
4. In the upcoming dialogue select „
YES
“ using the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
6.4.5.15 Enabling/disabling Non Return Time Delay - Submenu
NRTD cit
Ex factory, the Non Return Time Delay does apply for OTM codes as well. If
the Non Return Time Delay shall not apply for OTM codes, set this setting
to „
OFF
“.
Example: The lock is used in bank mode with NRTD set. The OTM codes are
used for exceptional openings, that need to be approved by a headquarter.
Authorization: Master Code
1. Select submenu „
NRTD cit
“.
2. Press
the
<ENTER>
key. It is displayed if the Non Return Time Delay is
enabled („on“) or disabled („off“).
3. Select either „
ON
“ or „
OFF
“ by toggling with the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
4. In the upcoming dialogue select „
YES
“ using the
<LEFT>
or
<RIGHT>
key, then press the
<ENTER>
key to confirm.
Summary of Contents for Axessor CIT
Page 1: ......
