Ski-Doo REV-XR 2009, Operator'S Manual

Page: 73 / 151

TUNE YOUR RIDE
To adjust, proceed as follows:
1. Start engine.
2. Press the MODE (M) button to se-
lect suspension mode.
When the air suspension mode is se-
lected, "AIR_SUSP" is displayed. The
display also shows the actual suspen-
sion setting (a number from 1 to 5, 1
being the softest setting).
3. Depress the heated throttle lever
switch as shown to increase or de-
crease air pressure.
mmo2008-003-009_d
VARIABLE INTENSITY
1. Heated throttle lever switch
2. Increase pressure
3. Decrease pressure
4. The desired set point appears on
the display. To confirm, press the
MODE (M) button or wait 5 sec-
onds.
mmo2009-005-040_a
1. Set point
2. Actual setting
Rear Springs Preload (Comfort)
IMPORTANT: Make sure that all ob-
jects to be transported are in place in
storage compartment and rear rack.
– Grab rear bumper and lift until sus-
pension is fully extended.
– From this point, rear of snowmobile
should collapse by 50 to 75 mm (2 to
3 in) when driver and passenger (if
so applicable) take place. Measure
at rear bumper as shown in next il-
lustration.
C
B
A
mmo2006-003-022_a
TYPICAL — PROPER ADJUSTMENT
A. Suspension fully extended
B. Suspension has collapse with driver,
passenger(s) and load added
C. Distance between dimension “A” and “B”,
must not exceed 50 to 75 mm (2 to 3 in),
see table
_______________
71