Ski-Doo REV-XR 2009, Operator'S Manual

Page: 92 / 151

MAINTENANCE PROCEDURES
Spark Plugs
Spark plugs inspection or replace-
ment must be done by an authorized
SKI-DOO dealer.
WARNING
To avoid fire hazard, never attempt
to check spark efficiency at spark
plugs or spark plug wires and nev-
er remove spark plugs on a E-TEC
engine.
Engine Stopper
600 HO E-TEC Model
Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove DESS key from post.
2. Remove the LH side panel, refer to
BODY
.
3. Remove drive belt guard, refer to
DRIVE BELT GUARD REMOVAL in
this section.
4. Loosen the three bolts retaining
the engine stopper to the engine
support without removing them.
mmo2009-003-013_a
1. Engine stopper
2. Engine stopper screws
3. Drive pulley
5. Apply a downward pressure on the
engine stopper with your fingers
while tightening the screws just
enough to obtain contact between
the screw heads and the surface of
the stopper.
6. Torque screws to 10 N•m
(89 lbf• in ).
NOTICE
Serious pulley damage
can occur if the engine stopper and
its screws are not properly installed.
Brake Fluid
Recommended Fluid
Use only DOT 4 brake fluid from a
sealed container. An opened contain-
er may be contaminated or may have
absorbed moisture from the air.
CAUTION To avoid serious
damage to the braking system, do
not use fluids other than the recom-
mended one, nor mix different fluids
for topping up.
Brake Fluid Level
NOTICE
Vehicle must be on a lev-
el surface before checking any fluid
levels.
Check brake fluid (DOT 4) in reservoir
for proper level. Add fluid (DOT 4) as
required.
NOTICE
Use only DOT 4 brake flu-
id from a sealed container. Never
use any other types of fluid.
90
______________