Protection
Protection Module Configuration with IMx-M Manager
2 - 102
SKF Multilog On-Line System IMx-M
User Manual
Figure 2 - 79.
Setting the IP Address by Using Hardware Switches.
It is required to set the first three part of the IP address of IP Settings
manually.
The last part of the IP address will be controlled by the HEX rotary switch
on IMx-M. For example, 10.0.0.1XY, where XY is derived from a combination of
the CMM + PRM slot number and the HEX rotary switch position (see the table
below).
Table 2-17: TCP/IP address/Slot ID when configured by HEX rotary switch.
HEX rotary
switch (x1)
TCP/IP address/Slot ID
CMM + PRM Slot
1
CMM + PRM Slot
2
CMM + PRM Slot
3
CMM + PRM Slot
4
0
1
2
3
9
A
F
Software defined
01
05
09
33
37
57
Software defined
02
06
10
34
38
58
Software defined
03
07
11
35
39
59
Software defined
04
08
12
36
40
60
Factory default configuration TCP/IP address: 10.0.0.1XY
These last two digits will also form the slot ID.
The HEX rotary switch has to be set manually.
The HEX rotary switch for IMx-M is located inside, back of the right-most
panel (looking at the rack from the front panel). In order to access it, first turn
off the power, then take the right-most panel out.
If the right-most slot has been mounted with a CMM + PRM pair, the CMM
must be dismounted first before the PRM due to the physical reason.
Otherwise, PRM can be damaged seriously. However, when mounting the
