1
- 15 -
951-171-010
Version 06
EN
1. Safety instructions
○
Carry out electrical connections only ac-
cording to the information in the valid
wiring diagram and taking the relevant
regulations and the local connection con-
ditions into account.
○
Do not touch cables or electrical compo-
nents with wet or damp hands.
○
Fuses must not be bypassed. Replace
defective fuses always by fuses of the
same type.
○
Undertake drilling at non-critical, non-
load bearing parts only. Use any available
boreholes. Do not damage lines and ca-
bles when drilling.
○
Observe possible abrasion points. Protect
the parts accordingly.
○
All components used must be designed
for:
- the maximum operating pressure
- the maximum/ minimum ambient
temperature
○
No parts of the centralized lubrication
system may be subjected to torsion,
shear, or bending.
○
Check all parts prior to their usage for
contamination and clean, if necessary.
○
Lubricant lines should be primed with
lubricant prior to installation. This makes
the subsequent ventilation of the system
easier.
○
Observe the specified tightening torques.
When tightening, use a calibrated torque
wrench.
○
When working with heavy parts use suit-
able lifting tools.
○
Avoid mixing up or wrong assembly
of dismantled parts. Mark these parts
accordingly.
1.19 Initial commissioning / daily start-up
Ensure that:
○
All safety devices are completely available
and functional
○
All connections are correctly connected
○
All parts are correctly installed
○
All warning labels on the product are
present completely, highly visible and
undamaged
○
Illegible or missing warning labels are to
be replaced without delay
