Simrad Simrad SP70, Installation Manual

Page: 79 / 230

Cable layout and connections
63
851-164336 / D
Cables
C1 - AC Power to the Display Unit
This is a standard mains supply cable. It is included in the delivery
with the optional Simrad display units. The mains voltage for the
Simrad LCD monitors is 115 or 230 Vac, and they will
automatically sense the current supply voltage. For other type of
displays, refer to the applicable documentation.
→
Cable details, page 186.
Observe the following procedure for the connection of the mains
supply to the display unit.
1 Connect the mains supply cable between the mains
connector at the rear side of the display unit and a normal
mains outlet.
If the delivered cable connector does not fit, replace it with a
suitable connector.
C2 - Display cable
This is a standard display cable, where VGA or DVI signal outputs
may be used. The cable is normally attached to the display, and
terminated in the computer end with a male 15-pin Delta connector
(VGA) or a special DVI connector. The cable is normally supplied
by the display manufacturer.
→
VGA Cable details on page 189.
Observe the following procedure for the connection of the display
unit to the Sonar Processor Unit.
1 Connect the display cable to the appropriate connector on the
circuit board in slot
J1 .
The circuit board in slot J1 in the computer provides two Delta
connectors. The top connector is for VGA, while the bottom is for
DVI.
C3 - AC Mains to Sonar Processor Unit
This is a standard mains supply cable. It is secured to the rear side
of the Sonar Processing Unit with a bracket. The mains voltage for
the Sonar processing Unit is 115 or 230 Vac, and it will
automatically sense the current supply voltage. The cable is
provided by Simrad.
→
Cable details, page 186.
Observe the following procedure for the connection of the mains
supply to the Sonar Processor Unit.
1 Connect the mains supply cable between the mains
connector at the rear side of the display unit and a normal
mains outlet.