Installation planning
23
851-164336 / D
2 INSTALLATION PLANNING
Note
For installation in a previously installed trunk system, first read
the information about sonar room requirements. Then, for a
previously installed trunk system, proceed to the
Hull Unit
installation description.
→
Sonar room requirements are described on page 26.
→
Installation of the hull unit is described on page 34.
2.1 General
This chapter provides the marine engineers responsible the
information necessary to plan and install the sonar’s Hull Unit
according to Simrad’s requirements.
Correct installation of the sonar transducer is vital to the system’s
performance. Several variables must be taken into consideration,
the most important of which is the vessel’s construction. This
guide is for use in selecting the best location for the transducer and
includes a brief description of areas to be avoided.
Note
Note that installation drawings must be supplied by the shipyard.
The installation must be approved by the vessel’s national registry
and corresponding maritime authority and/or classification
society. The shipowner and shipyard performing the installation
are responsible for obtaining and paying for installation approval.
Simrad offers free advice for installation planning. Proposed
arrangements may be sent for commentary or suggestions supplied
by Simrad. The following drawings should be submitted should
assistance be requested:
•
General arrangement
•
Body plan and drawings of relevant bottom tanks and
coffer-dams
•
Lines plan
Summary of Contents for Simrad SP70
