Simplex TFX-500M, Operator'S Manual

Page: 12 / 44

Figure 1--4 (a) FIRE and Zone Alarm Indicators, (b) display FIRE ALARM message.
FIRE
TROUBLE
SUPERVISORY
POWER
PANEL SILENCE
ALARM SILENCE
SYSTEM RESET
DRILL
ENABLE
OFF
LAMP
TEST
LAMP
TEST
FIRE ALARM
Main Workshop
Welding Area
Zone 2 A48 001
(1) Alarm message
(2) Zone message
(3) Point message
(4) Zone number,
point ID, outstanding
events
1 2 3
4 5 6
7 8 9
0
NO YES
DELETE ENTER
FAST
ACCESS
B
Y
OPERATOR DISPLAY MODULE
QUIT
FIRE ALARM
Main Workshop
Zone 2 A48 001
FIRE ALARM SYSTEM INDICATOR
(RED)
ZONE ALARM INDICATOR
(RED)
ZONE ALARM INDICATOR
(RED)
(a)
(b)
AUTOCALL TFX Fire Control System Operator’s Manual
4
1.1. Quick Response— Fire Alarms
Your company or facility should have fire response guidelines. In case of a FIRE emergency, follow those procedures.
Here is what you will observe at the AUTOCALL TFX-500M/800M Fire Control Panel in case of a FIRE alarm.
What You do What happens
Look at the AUTOCALL TFX-500M/800M
control panels to see Alarms. Listen for Alarm
signals.
1 Two red FIRE ALARM LEDs light.
2 Red ZONE ALARM LED(s) flash.
3 Buzzer sounds.
4 Alarm bells, horns, etc. sound.
5 Display says FIRE ALARM on first line.
Read the display to determine where the
alarm originated.
Display shows zone and point identification messages. See Figure
above.
Find the location and cause of the alarm.
Follow your building and company
procedures.
Alarm bells/horns, lights, buzzers, and displays continue.
Respond according to your facility’s
emergency response procedure.
Alarm bells/horns, lights, buzzers, and displays continue.
ACCEPT the alarms (See Section 1.4,
page 7 .)
This provides a list of alarms that have been activated.
After cause has been found, response
made,and alarms accepted, SILENCE the
alarms. (See Section 1.5, page 8 )
(See Section 1.5, page 8 .)
RESET the system alarms. (See Section 1.6,
page 9 .)
(See Section 1.6, page 9 .)
WARNING: Do not reset the system until all alarms have been investigated and accepted.
firealarmresources.com