Operating manual - English
UNOCODE PRO
Copyright Silca 2017
63
6.11.3
MACHINE OPTIONS [PAGE 2/4]
the display shows:
Machine data
Model:
machine model.
Serial No:
the serial number corresponding to that on the ID plate located on the
back of the machine.
Keys cut:
cutting completed.
Operating System Version:
version of the machine operating system.
Carriage speed
Fast speed:
the speed at which the carriages approach the cutting zone before
cutting is started. The set speed is that for ideal conditions, but the operator can change it from a minimum of 1000 to a
maximum of 5000 (Silca configuration: 4000 UC Pro - 5000 UC Pro Flat Steel).
Cutting speed:
corresponds to the speed at which the carriage advances during key-cutting. The set speed (500 UC Pro - 850 UC Pro Flat
Steel) is that for ideal conditions, but the operator can change it from a minimum of 200 to a maximum of 1600.
Reading speed:
Recommended reading speed is 350; the operator can change from a minimum of 100 to a maximum of 350.
Speed variation limit (percentage):
Indicates cutting speed variation expressed as a percentage applicable as User Parameters to a cutting card. The default
percentage value (Attention: + 50% to -50%) is for ideal conditions, but the operator can edit this value (see “Editing cutting
speed” page 30).
6.11.4
MACHINE OPTIONS [PAGE 3/4]
The display shows:
Head stop processing
Min. cut distance:
The number shown on the machine’s display represents the X axis
distance between the key blank shoulder and the beginning of the first
cut (fig. 41).
This function is extremely important with keys that require cuts on
both sides as it ensures precise positioning on the key 2nd side.
The set figure is 50 hundredths of a mm, which can be varied between
min.0 - max. 90 hundredths of a mm.
ATTENTION: settings that are too high may render precise cuts
impossible, with the following message on the display:
Fig. 41
Rectify Key Stop:
The machine does not normally allow for key stop rectification.
However, it is possible, when necessary, to rectify the stop by removing a part of it, and arrange cutting according to the new
key stop created.
If the operation is enabled, 4 items are required:
Rectification thickness X:
thickness of the part to be removed, quantified in hundredths of a mm (min. 0 - max.90)
Key stop height Y:
height of the stop read by a gauge on the key, quantified in hundredths of a mm. E.g.: Y = 3 mm = 300 hundredths of a mm
(min.100 - max.999).
Depth H:
depth of the part to be removed, quantified in hundredths of a mm, relating to the key blank measurements (min.0 - max.600).
Length L:
distance in hundredths of a mm of the axis from the cutter, relating to X (min.0 - max.4000).
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!
