Operating manual - English
UNOCODE PRO
Copyright Silca 2017
11
3
MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
It is supplied ready for use and does not need any special set up. However, the operator may have to control a few things
before operating the machine.
3.1 C
HECKING
FOR
DAMAGE
UNOCODE PRO is solid and compact and will not normally damage if transport, unpacking and installation have all been
carried out according to the instructions in this manual. However, it is always advisable to check that the machine has not
suffered any damage.
3.2 E
NVIRONMENTAL
CONDITIONS
To ensure that the best use is made of the key-cutting machine, it is important to place it in a well-aired area which is not
too damp.
The ideal conditions for the machine are: temperature between 10°C and 40°C; relative humidity: approx 60%
3.3 P
OSITIONING
AND
INSTALLATION
1) Place the machine on a horizontal surface, solid enough to support the weight of 38 Kg.
- to work with ease, we suggest that the workbench be approximately the height of the operator’s hip.
- it is important to leave clearance of at least 30 cm behind the machine and on each side to ensure proper venti-
lation.
2) Ensure that the machines voltage is the same as that of the mains power supply, which must be properly earthed
and provided with a differential switch.
3) Connect the power supply cable to the power supply socket.
Fig. 9
3.4 D
ESCRIPTION
OF
WORK
STATION
The machine needs only one operator, who has the following controls at his/her disposal (fig. 6, page 6):
• master switch placed on the back of the machine
• key-positioning clamp
• keyboard
• display
• emergency button
100/120 cm
30 cm
30 cm
30 cm
