UNOCODE PRO
Operating manual - English
20
Copyright Silca 2017
6.3 C
OPY
FROM
O
RIGINAL
In the initial screen press F1 to use the function.
This function is used to make a direct copy from the key, without
further stages.
The “Copy from Original” window shows certain data and icons:
• Cutter to use (cannot be edited)
• Clamp to use (cannot be edited)
• Stop position (settings go from 0 to 6; other values can be
written but will not be confirmed)
• No. of cutting step: (can be edited) increases the number of
cutting passes (max. 3).
• Pieces = 1 / 1(up to 999 pcs. can be set)
Stop distance:
The number shown on the machine’s display represents the X axis
distance between the key blank shoulder and the beginning of the first
cut.
This function is extremely important with keys that require cuts on
both sides as it ensures precise positioning on the key 2nd side.
The set figure is 50 hundredths of a mm, which can be varied:
• min.0 - max. 99 hundredths of a mm.
ATTENTION: settings that are too high may render precise cuts
impossible, with the following message on the display:
Note: the icon in the lower left corner of the menu can be activated by the F4 key (see Ch.6.4 "Copy
with adjustments", page 21).
Set the number of pieces to be cut, the type of Stop to use (up/down arrow keys to move and numerical keys for entry).
As illustrated in the figure, with Stop 0 and pieces 1, fit the key blank into the clamp on the cutter side and the original key
into the clamp on the reader side. Lower the right-hand clamp gauge and press START to begin.
Note: after placing the original key in the r/h clamp, remember to
lower the gauge. If this is not done, when reading starts the machine
will stop and show the following message on the display:
In this case lower the gauge and press START to continue.
MIN. Parameter of
DISTANCE FROM STOP
is incompatible with
selected card!
2
0
A
1
3
4
Stop 2
Gauge
