SIGMATEK BWH, Configuration

Page: 55 / 67

CONFIGURATION HGW-BWH
change the required connection parameters. Information on the file structure and
parameters can be found here: 9.1.3 File Structure and Parameters wireless.conf and
wireless2.conf
Save the changes using the “Save on Plc” button.
4. Restart the device for all settings to take effect.
9.4 Configuring a Single WLAN Access Point
To configure an access point in single WLAN mode, follow the steps below:
1. Open the „C:\autoexec.lsl“ file and if not available, insert the following lines at the
end of the file:
Example 2.4 GHz:
SET IP 11 HOSTADDR 192.168.2.1
SET IP 11 SUBNET 255.255.255.0
WLANAP 11
Example 5 GHz:
SET IP 10 HOSTADDR 192.168.1.1
SET IP 10 SUBNET 255.255.255.0
WLANAP 10
The IP address for IP 10 must be adapted to your requirements and the
network environment accordingly.
The access point can be configured for 2.4 or 5 GHz, this is set via the
parameters WLANAP 10 for 5 GHz and WLANAP 11 for 2.4 GHz. The settings
for the network from the rsdbd.conf are used based on the network.
Save the changes using the “Save onPlc”. button.
2. Open the „C:\lslsys\rsdbd.conf“ file.
The possible configurations and parameters are described under 9.1.2 File Structure
and Parameters rsdbd.conf
Save the settings using the “Save on PLC” button.
The settings are then enabled with the next restart.
17.05.2022 Page 53