SIGMATEK BWH, Configuration

Page: 56 / 67

HGW-BWH CONFIGURATION
9.5 Configuring a Single WLAN Client Device
To configure an access point in single WLAN mode (for IP 10 in this example), follow the steps
below:
1. Open the “C:\autoexec.lsl” file and if not available, insert the following lines at the end
of the file:
SET IP 10 HOSTADDR 192.168.1.2
SET IP 10 SUBNET 255.255.255.0
The IP address for IP 10 must be adapted to your requirements and the
network environment accordingly.
Ensure that the entry “WLANAP x” no longer appears in the file.
Save the changes using the “Save on Plc” button.
2. Open the “C:\lslsys\wireless.conf” file
The “wireless.conf” file is used to configure interface 10 for the 5 GHz network. Here,
change the required connection parameters. Information on the file structure and
parameters can be found under: 9.1.3 File Structure and Parameters wireless.conf
and wireless2.conf
Save the changes using the “Save on Plc” button.
3. Restart the device for all settings to take effect.
9.6 Restoring Default Settings
To restore the factory settings, the following files must be deleted:
C:\lslsys\rsdbd.conf
C:\lslsys\wireless.conf
C:\lslsys\wireless2.conf
The factor settings are restored after a reboot.
Page 54 17.05.2022