SIGMATEK BWH, Configuration

Page: 60 / 67

HGW-BWH CONFIGURATION
The example shows the basic configuration of the system. An additional change in the
parameters is possible, however, not required for simple operation.The settings are first
enabled after a restart.
10.2 DHCP Client
The DHCP client is installed as a standard element in every SIGMATEK control and is always
available.
10.2.1 Configuring the DHCP Client
1. Open the “C:\autoexec.lsl” file and if interfaces IP 10 and IP 11 are not available,
insert the following lines at the end of the file:
set ip 10 hostaddr dhcp
set ip 11 hostaddr dhcp
2. For each IP interface that uses DHCP as the source for the IP address, a "set ip" entry
must be created as described in the example.
3. The documented entries are provided for the basic configuration only. More
information can be found in the “DHCP CLIENT” documentation, which can be
acquired from SIGMATEK support.
Page 58 17.05.2022