SIGMATEK BWH, Configuration

Page: 54 / 67

HGW-BWH CONFIGURATION
In the above configuration, IP 10 is the 5 GHz network and IP 11 is the 2.4 GHz
network.
Save the changes using the “Save onPlc”. button.
2. Open the “C:\lslsys\rsdbd.conf” file
The possible configurations and parameters are described under 9.1.2 File
Structure and Parameters rsdbd.conf
Save the settings using the “Save on PLC” button.
3. The settings are then enabled with the next restart.
9.3 Configuring a Dual WLAN (RSDB) Client Device
To configure client in dual WLAN mode (RSDB), follow the steps below:
1. Open the “C:\autoexec.lsl” file and if unavailable, insert the following lines into the
file:
SET IP 10 HOSTADDR 192.168.1.2
SET IP 10 SUBNET 255.255.255.0
SET IP 11 HOSTADDR 192.168.2.2
SET IP 11 SUBNET 255.255.255.0
The IP address for IP 10 and IP 11 must be adapted to your requirements and
the network environment accordingly.In this configuration, IP 10 is the 5 GHz
network and IP 11 is the 2.4 GHz network.
Ensure that the entry “WLANAP x” no longer appears in the autoexec.lsl.
Save the changes using the “Save on Plc” button.
2. Open the “C:\lslsys\wireless.conf” file
The “wireless.conf” file is used to configure interface 10 for the 5 GHz network. Here,
change the required connection parameters. Information on the file structure and
parameters can be found under: 9.1.3 File Structure and Parameters wireless.conf
and wireless2.conf
Save the changes using the “Save on Plc” button.
3. Open the “C:\lslsys\wireless2.conf” file
The “wireless.conf” file is used to configure interface 11 for the 2.4 GHz network. Here,
Page 52 17.05.2022