Siemens TS2000, Service Manual

Page: 40 / 65

TS2000 Service Manual RD7409290-0 Rev. F
5-2
11.
Unscrew the eight screws that secure the computer to the bottom of
the main frame.
12.
Slide the computer out carefully and slide the new computer into
place.
13.
Replace and tighten the eight screws that secure the computer in
place (at the bottom).
14.
Replace and tighten the four screws on the side edges of the front
panel (two on the bottom and two on the top) and reposition the
front panel.
15.
Connect the front panel switch (the connector that is on the right
side of the T1 transformer).
16.
Turn the whole system over. From the inside of the system, replace
and tighten the three screws that are located on the inside of the
bottom front panel.
17.
Turn the system right side up again. From inside the system,
replace and tighten the three screws that are located on the upper
front panel.
18.
Reposition the bottom of the main system enclosure by replacing
and tightening the four screws (two on each side) that secure it in
place.
19.
Reposition the upper cover of the main system enclosure (Main
Console) by replacing and tightening the four screws (two on each
side).
20.
Replace the main enclosure (Main Console) back on the second
shelf of the cart.
21.
Connect all the cables from the Computer connection panel.
22.
Connect the main power connection, the power from the system to
the monitor, the video monitor cable connection, the mouse and the
keyboard connections.
23.
Connect the probes back to the PSB board.
24.
Connect all cables from the PM connection panel (located to the
upper left side of the back of the main system).
25.
Connect the system to the electrical outlet and turn the system on;
the system is ready for use.
SPB7-520.840.01.01.02