Siemens SICAM Q100, Device Manual, Page: 212 / 376

8 Operation at Use of a PC
8.3 Configuration of the Device
212 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Parameterizing a SICAM Subdevice in SICAM Q100
If you want to change the settings of a SICAM subdevice (for example, Subdevice 1: SICAM IO), proceed as
follows:
✧
In the navigation window, click the
Administrative
menu and the menu item
SICAM subdevices.
The
SICAM subdevices
input/output window opens.
✧
In the
Subdevice 1
list box, select the entry
SICAM IO.
If you select
-none-
, no entries exist for the subdevice.
Figure 8-68 Configure Tab, SICAM Subdevices Input/Output Window
✧
In the list boxes, select the respective indication according to Table 8-29. Enter the desired values in the
fields.
✧
After the parameterization click
Send
.
After clicking
Send
, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧
If you do not want to make any additional settings, continue with the
Activation
of the device configuration
according to section
Activating the Set of Parameters
. If you want to change other settings, enter the
changes and then enable the device configuration as described in section
Activating the Set of
Parameters
.
NOTE
Indication 1 from remote
and
Indication 2 from remote
are provided for controlling the two binary outputs
of the SICAM Q100. Therefore,
Indication 3 from remote
is the first assigned indication as
Source of output
of the SICAM subdevices.