Installation Instructions
Electronic Trip Unit and Rating Plug
8.) Replace circuit breaker front cover.
Replace the front cover. Then replace the eight (8) front
cover screws.
9.) Re-install the eight screws that hold the front cover in place.
14
A
DANGER
H azardou s Voltage.
Will cau s e s evere injury or death.
Turn power off and lock out supply
ing device before ins talling.
CAUTION: Do not attempt to install a rating plug with
the breaker "Closed" or "Charged". Make certain
breaker is "Open" and "Discharged" as shown above.
Personal injury or mechanical damage may occur.
Check to see that the breaker is open before inserting or
removing a rating plug. The breaker should always be in
the open position when there is not a rating plug in the
trip unit.
1
.) Remove the trip unit screws that hold the transparent cover.
Th� rating plug and adjustments on the front panel of the trip
unit are protected by a transparent cover. Prior to installing
a rating plug or setting the adjustments on the trip unit, this
cover must be removed. Unscrew the two screws that hold
it in place.
2.) With a small screwdriver entl
end and remove
it
caref
�
l
�
y pry the cover loose at
nn"'
-
www
. ElectricalPartManuals
. com
