SICK OD2000, Operating Instructions Manual

Page: 37 / 58

Parameter Value Factory settings
Q1 Min. height jump 0 mm ... 2,147.48 mm OD2000- 030 / 050 : 0.50 mm
OD2000- 245 / 350 / 700 : 10.00 mm
Q1 Max. Height jump 0 mm ... 2,147.48 mm OD2000- 030 / 050 : 2.00 mm
OD2000- 245 / 350 / 700 : 100.00 mm
Q1 Jump direction Positive
Negative
Both Both
Q1 Cycle offset 1 ... 10,000 50
Q1 Switch point logic High-active
Low-active High-active
Q1 Timer mode Off
Switch-on delay
Switch-off delay
Switch-on/off delay
Pulse (one shot) Off
Q1 Timer setup 1 ms ... 30,000 ms 1 ms
Q1 Hysteresis 0 mm ... 2,147.48 mm OD2000- 030 : 0.1 mm
OD2000- 050 : 0.2 mm
OD2000- 245 : 0.5 mm
OD2000- 350 : 1 mm
OD2000- 700 : 1.5 mm
7.4.3.7.1 Min. / max. height change
The Min. height jump and Max. height jump parameters define the smallest and largest dif‐
ference between the current measured value and the comparison value in millimeters.
The two measured values must differ by this amount for there to be an edge height
change. The function only takes into account the difference between two measured
values and is independent of the absolute distance of the object.
7.4.3.7.2 Change direction
The Jump direction parameter defines the direction in which measured value jumps are
detected.
• Positive : Only changes in measured values within the set limits which result in
larger distances are detected (description applies to factory setting).
• Negative : Only changes in measured values within the set limits which result in
smaller distances are detected (description applies to factory setting).
• Both : All changes in measured values within the set limits are detected.
7.4.3.7.3 Cycle offset
The cycle offset parameter specifies which previous measured value is compared with
the value currently measured.
OPERATION
7
8026231//2021-11-17 | SICK O P E R A T I N G I N S T R U C T I O N S | OD2000 37
Subject to change without notice