SICK OD2000, Operating Instructions Manual

Page: 29 / 58

Parameter Value Factory setting
ROI near Setting the switching point
OD2000- 030 :
-5.04 mm ... +5.75 mm
OD2000-
050 :
-10.10 mm ... +11.50 mm
OD2000-
245 :
-176.75 mm ... +189.00 mm
OD2000-
350 :
-252.50 mm ... +271.00 mm
OD2000-
700 :
-505.00 mm ... +550.00 mm
ROI near :
OD2000- 030 : -5.04 mm
OD2000- 050 : -10.10 mm
OD2000- 245 : -176.75 mm
OD2000- 350 : -252.50 mm
OD2000- 700 : -505.00 mm
ROI far ROI far :
OD2000- 030 : +5.75 mm
OD2000- 050 : +11.50 mm
OD2000- 245 : +189.00 mm
OD2000- 350 : +271.00 mm
OD2000- 700 : +550.00 mm
7.4.1.6 Error mode
If the device cannot measure the distance, a substitute value is output. The behavior of
the device in the event of faulty measurements can be set via several parameters.
Possible causes of faults
• Measuring object outside the measuring range
• Received light signal not strong enough
• Sender switched off
Parameter
•
Error mode > User-defined value : If no measurement is possible, the set Substitute
value is displayed and held until a valid measured value is available again.
•
Error mode > Hold last value : If no measurement is possible, the last valid measured
value is displayed and held until a valid measured value is available again.
•
Error mode > Hold last value + timer : If no measurement is possible, the last valid
measured value is displayed and held for the time set under Error suppression time .
Once this time has elapsed, the set Substitute value is displayed and held until a
valid measured value is available again.
•
Substitute value : Set a numerical value as a substitute value. If no measurement is
possible, the substitute value is output.
•
Error suppression time : Set a time for which the last valid measured value is dis‐
played and held. With this function, the Hold last value + timer error mode must be
activated.
Setting error mode
> Measurement > > Error mode > > Select option >
Parameter Value Factory setting
Error mode User-defined value
Hold last value
Hold last value + timer User-defined value
Setting substitute value
> Measurement > > Substitute value > > Set value >
Parameter Value Factory setting
Substitute value -2,000.00 mm ... +2,000.00 mm +2,000.00 mm
Setting error suppression time
> Measurement > > Error suppression time > > Set value >
OPERATION
7
8026231//2021-11-17 | SICK O P E R A T I N G I N S T R U C T I O N S | OD2000 29
Subject to change without notice