6
Electrical installation
6.1
Wiring instructions
NOTE
Pre-assembled cables can be found online at:
•
NOTICE
Faults during operation and device or system defects!
Incorrect wiring may result in operational faults and defects.
■
Follow the wiring notes precisely.
The enclosure rating stated in the technical data is achieved only with a screwed plug
connector or protective cap.
Configure the circuits connected to the device as ES1 circuits or as SELV circuits (SELV
= Safety Extra Low Voltage). The voltage source must meet the requirements of ES1
and PS2 (EN 62368-1) or SELV and LPS (EN 60950-1).
Connect the connecting cables in a de-energized state. Do not switch on the supply
voltage until installation is complete and all connecting cables are connected to the
device and control.
6.2
Connecting the device electrically
NOTE
The connection diagram, and information on inputs and outputs, can be found on the
side plate on the device.
1.
Ensure that the voltage supply is not connected.
2.
Observe the wiring instructions,
see "Wiring instructions", page 19
3.
Connect the device according to the connection diagram.
1
4
3
5
2
L+
1
brn
M
3
blu
Q1/C
4
blk
Q2/Q
A
2
wht
In1
5
gra
Figure 7: Connection diagram, 5-pin male connector
Contact
Identification
Wire color
Description
1
L+
Brown
Supply voltage,
2
Q2 / Q
A
White
Output 2: Analog output / Digital output 2
(push-pull stage)
ELECTRICAL INSTALLATION
6
8026231//2021-11-17 | SICK
O P E R A T I N G I N S T R U C T I O N S | OD2000
19
Subject to change without notice
