SHP SHP2000iE, Manual

Page: 110 / 140

‐
109
‐

Parallel Terminal 1 output voltage is very high. Operators must
be protected from electric shock at all times. Do not operate
with wet hands.

Do not allow operation by children without supervision. Do not
expose the generator to rain, moisture or snow.

Make sure to ground (earth) the generator with Parallel Kit 2
when the electric appliance is earthed.
NOTE

Never connect the generator in parallel with any other
generator.

Never connect or remove the Parallel Kit 2 when the generator
is running.

For single generator operation, the Parallel Kit 2 must be
removed.

If an appliance begins to operate abnormally, becomes
sluggish or stops suddenly, turn it off immediately. Then
disconnect the appliance from the receptacles of the Parallel
Kit 2, and determine whether the problem is the appliance, or
if the rated load capacity of the generator has been exceeded.

The ECO Switch 3 must be in the same position on both
generators.

Make sure that the electrical appliance rated power does not
exceed the total rated power of two generators. If the electrical
appliance is inductive load or capacitive load, its rated power
should be smaller.

Most motorized appliances require more than their rated
wattage for startup. When an electric motor is started, the
OVERLOAD LED (red) 5 may light up. This is normal if the
OVERLOAD LED (red) 5 lights up after a few seconds.