SHP SHP2000iE, Manual

Page: 108 / 140

‐
107
‐
battery. Remove the Charging Cable 1 from the generator after the
battery has been fully charged.
NOTE

Do NOT connect the Charging Cable 1 to the AC
Receptacle 7, as the AC output voltage is very high, and
operators will be in danger of electrical shock hazard.

The DC Receptacle 2 should ONLY be used for charging 12V
Lead-acid batteries. Of course, it can also supply power for
some 12V electrical appliances whose power cannot exceed
100W.

DO NOT overcharge batteries or leave unattended while
charging.

ALWAYS keep Red and Black clips separated while the cable is
connected to the generator.

NEVER reverse the polarity when connecting the battery
terminals to the charging jack. Severe damage may occur to
the generator and battery.

An overloaded DC circuit or a wiring problem will trip the DC
Circuit Breaker 6(PUSH button extends out). If this happens,
wait a few minutes before pushing in the DC Circuit Breaker 6
to resume operation. If the DC Circuit Breaker 6 continues to
go OFF, discontinue charging and contact your authorized
generator dealer.
7.2 DISCONNECTING THE BATTERY CHARGING CABLE:
(1). Turn the Engine Switch to the “OFF” position to stop the engine
after the battery das been fully charged.
(2). Disconnect the Charging Cable 1 from the DC Receptacle 2 of the
generator.
(3). Disconnect the Black Charger Clip 5 of the Charging Cable 1 from