SHP SHP2000iE, Manual

Page: 102 / 140

‐
101
‐
6.1 USING THE GENERATOR:
After starting the engine, let it run for 2 or 3 minutes to warm up.
You can then use the generator as follows:
(1). Make sure the READY LED (green) 4 lights up.
(2). Turn the ECO Switch 1 to the "ON" position to use the Economy
Control System.
This system controls the engine speed
according to the connected load. This results in better fuel
consumption and less noise. (3). Connect the plug to the generator
AC Receptacles 2 for AC electric devices.
(4). Turn on the electric devices for operation.

AC output voltage is very high. Operators must be protected
from electric shock at all times. Do not operate with wet hands.

Do not allow it to be operated by children without supervision.
Do not expose the generator to rain, moisture or snow.

Be sure to ground (earth) the generator when the electric
appliance is earthed.
NOTE

The ECO Switch 1 must be turned to the “OFF” position
when using electric devices that require a large starting current,
such as a heavy compressor or some high electrical loads.

Make sure all electric devices, including the lines and plug
"OFF" position
"ON" position